Tanaka TED-210 User Manual download pdf (Page 11)

www.tanaka-usa.com

10 [email protected]

Owner’s Manual

TED-210/TED-262L/R/DH/HS

Cleaning the cylinder fins (Fig. 3-6)

When wood chips are caught between cylinder fins (1), the engine may overheat, resulting in lower output. To avoid this,

always keep cylinder fins and fan case clean. Every 100 Operating hours, or once a year (more often if conditions require),

clean fins and external surfaces of engine of dust, dirt and oil deposits, which can contribute to improper cooling.

Cleaning the muffler (Fig. 3-7)

Remove the muffler and spark arrestor (if so equipped), and clean out any excess carbon from the exhaust port or muffler

inlet every 100 hours of operation.

For long-term storage

Drain all fuel from the fuel tank. Start and let engine run until it stops. Repair any damage which has resulted from use.

Clean the unit with a clean rag, or the use of high pressure air hose. Put a few drops of two-cycle engine oil into the

cylinder through the spark plug hole, and spin the engine over several times to distribute oil. Cover the unit and store it in

a dry area.

Fuel filter (Fig. 3-5)

Remove the fuel filter from the fuel tank and inspect.

Replace with new filter if damaged or soiled. Replace

with new filter if needed. After that, push the filter into

the tank completely.

Gear case (Fig. 3-4, 4B)

Apply a good quality lithium based grease through the

grease fitting. Lubrication should be applied at 50 hour

intervals and more frequent under heavy use.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Tanaka TED-210 User Manual Page 11