Tanaka TED-210 User Manual download pdf (Page 5)

www.tanaka-usa.com

4 [email protected]

Owner’s Manual

TED-210/TED-262L/R/DH/HS

Assembly procedures

Assembling (Fig. 1-1, 1B, 1C)

1. Assemble the handle (1), which is supplied with the unit to the gear case.

2. Screw the chuck unit (2) into the drive shaft (clockwise) after the collar B (3) has been installed.

NOTE! The collar B(3) is not used on Model TED-262 series.

3. Insert the drill bit to be used after opening the chuck by the chuck handle (4) and tighten the chuck by the handle.

Selection of a Suitable Bit

Choose a drill bit according to material to be drilled.

Operating procedures

Fuel (Fig. 2-1)

WARNING!

The power drill is equipped with a two-stroke engine. Always run the

engine on fuel, which is mixed with oil.

Provide good ventilation, when fueling or handling fuel.

Fuel

• Always use branded 89 octane unleaded gasoline.

• Use Tanaka two-cycle oil or a quality two-cycle oil at mixing ratio of

25-50:1 (Gasoline (A) : Oil (B)), only for the

state of California at 50: 1.

• Never use multi-grade oil (10 W/30) or waste oil.

• Always mix fuel and oil in a separate clean container.

• Always start by filling half the amount of fuel, which is to be used.

Then add the whole amount of oil. Mix

(shake) the fuel mixture.

• Add the remaining amount of fuel.

• Mix (shake) the fuel-mix thoroughly before filling the fuel tank.

Fueling

WARNING!

• Always shut off the engine before refueling.

• Slowly open the fuel tank, when filling up with fuel, so that possible over-pressure disappears.

• Tighten the fuel cap carefully, after fueling.

• Always move the unit at least 3 m (10 ft.) from the fueling area before starting.

Before fueling, clean the tank cap area carefully, to ensure that no dirt falls into the tank.

Make sure that the fuel is well mixed by shaking the container, before fueling.

1 2 3 4 5 6 7 8 9 10 ... 13 14

No comments

Tanaka TED-210 User Manual Page 5