Tanaka TBC-2251 User Manual download pdf (Page 7)

www.tanaka-usa.com 6 [email protected]

Owner’s Manual

TBC-2211,TBC-2251,TBC-230/B

Throttle wire/stop cord

Remove the air cleaner cover. (Fig. 1-4)

Connect stop cords. (Fig. 1 -5)

Set outer receiver (1) (if so provided) into wire guide and put

throttle wire through the outer receiver. (Fig. 1 -4)

Connect throttle wire end to carburetor. (Fig. 1 -6)

Cover throttle wire and stop cords together with protective

tube provided up to air cleaner cover. (Fig. 1 -7)

Installation of blade guard (Fig. 1-8, 8B, 8C)

Install the blade guard on the drive shaft tube against angle

transmission (2) / gear case (1). Tighten the guard bracket firmly so

that the blade guard does not swing or move down during operation.

When using a trimmer head (2), locate the guard above the angle

transmission. (Fig. 1-8D, 9B)

CAUTION!

Do not attempt to install metal blade on the curved shaft trimmer.

It is very dangerous.

CAUTION!

Some blade guards are equipped with sharp line limiters. Be

careful with handling it.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

No comments

Tanaka TBC-2251 User Manual Page 7